Recent articles

The Phase Composition and Mechanical Properties of Al₂O₃-TiN-TiC Ceramic Materials with Different Ni Content

Y. Fei, Ch. Huang, H. Liu

received Febuary 12, 2019, received in revised form April 7, 2019, accepted June 18, 2019

Vol. 10, No. 2, Pages 1-8   DOI: 10.4416/JCST2019-00012

Keywords: Al₂O₃-TiN-TiC ceramic, Ni content, phase composition, mechanical properties

Abstract  |  References  |  Full Article (PDF)

Influence of the Printing Parameters on the Quality of Alumina Ceramics Shaped by UV-LCM Technology

P. Ożóg, G. Blugan, D. Kata, T. Graule

received February 22, 2019, received in revised form July 6, 2019, accepted July 26, 2019

Vol. 10, No. 2, Pages 1-10   DOI: 10.4416/JCST2019-00023

Keywords: Alumina, LCM, 3D printing, UV-curing, photopolymerisation

Abstract  |  References  |  Full Article (PDF)

Design and Experiment of a 3D Printing System for Ceramics by Continuous Extrusion

Y. CHAO, X. LIU

received June 24, 2019, received in revised form August 12, 2019, accepted August 14, 2019

Vol. 10, No. 2, Pages 1-10   DOI: 10.4416/JCST2019-00048

Keywords: 3D ceramic printing, continuous extrusion, nozzle extrusion device, bonding quality.

Abstract  |  References  |  Full Article (PDF)

Avoiding Thermal-Stress-Induced Failures by Design Optimization when Brazing Perlucor® to Inconel® 718 Components

L. Spatafora, J. Isele, H.-J. Ritzhaupt-Kleissl, V. Hagenmeyer, J. Aktaa

received February 5, 2019, received in revised form July 5, 2019, accepted July 26, 2019

Vol. 10, No. 2, Pages 1-10   DOI: 10.4416/JCST2019-00011

Keywords: Metal-ceramic-joint, residual stress calculation, failure probability, active brazing

Abstract  |  References  |  Full Article (PDF)

Effect of the Evolution of Rheological Behavior over Deagglomeration Time on Optical Transparency of Polycrystalline Alumina Ceramics

A. Rahimian, M. Torki, S. Ghazanfari, B. Movahedi, R. Emadi

received June 23, 2019, received in revised form August 6, 2019, accepted August 15, 2019

Vol. 10, No. 2, Pages 1-8   DOI: 10.4416/JCST2019-00047

Keywords: Optical materials, sintering, optical properties, ball milling.

Abstract  |  References  |  Full Article (PDF)

Low-Temperature Sintering and Microwave Dielectric Properties of Li₂O-3ZnO-5TiO₂ Ceramics Doped with B₂O₃

J. Liu, J. Zhu, Y. Zeng

received July 8, 2019, received in revised form August 9, 2019, accepted August 14, 2019

Vol. 10, No. 2, Pages 1-8   DOI: 10.4416/JCST2019-00055

Keywords: Microwave dielectric properties, LTCC, Li₂O-3ZnO-5TiO₂

Abstract  |  References  |  Full Article (PDF)