Issues

The Phase Composition and Mechanical Properties of Al₂O₃-TiN-TiC Ceramic Materials with Different Ni Content

Y. Fei, Ch. Huang, H. Liu

Vol. 10, No. 2, Pages 1-8   DOI: 10.4416/JCST2019-00012

Keywords: Al₂O₃-TiN-TiC ceramic, Ni content, phase composition, mechanical properties

Abstract  |  References  |  Full Article

Influence of the Printing Parameters on the Quality of Alumina Ceramics Shaped by UV-LCM Technology

P. Ożóg, G. Blugan, D. Kata, T. Graule

Vol. 10, No. 2, Pages 1-10   DOI: 10.4416/JCST2019-00023

Keywords: Alumina, LCM, 3D printing, UV-curing, photopolymerisation

Abstract  |  References  |  Full Article

Design and Experiment of a 3D Printing System for Ceramics by Continuous Extrusion

Y. CHAO, X. LIU

Vol. 10, No. 2, Pages 1-10   DOI: 10.4416/JCST2019-00048

Keywords: 3D ceramic printing, continuous extrusion, nozzle extrusion device, bonding quality.

Abstract  |  References  |  Full Article

Avoiding Thermal-Stress-Induced Failures by Design Optimization when Brazing Perlucor® to Inconel® 718 Components

L. Spatafora, J. Isele, H.-J. Ritzhaupt-Kleissl, V. Hagenmeyer, J. Aktaa

Vol. 10, No. 2, Pages 1-10   DOI: 10.4416/JCST2019-00011

Keywords: Metal-ceramic-joint, residual stress calculation, failure probability, active brazing

Abstract  |  References  |  Full Article

Effect of the Evolution of Rheological Behavior over Deagglomeration Time on Optical Transparency of Polycrystalline Alumina Ceramics

A. Rahimian, M. Torki, S. Ghazanfari, B. Movahedi, R. Emadi

Vol. 10, No. 2, Pages 1-8   DOI: 10.4416/JCST2019-00047

Keywords: Optical materials, sintering, optical properties, ball milling.

Abstract  |  References  |  Full Article

Low-Temperature Sintering and Microwave Dielectric Properties of Li₂O-3ZnO-5TiO₂ Ceramics Doped with B₂O₃

J. Liu, J. Zhu, Y. Zeng

Vol. 10, No. 2, Pages 1-8   DOI: 10.4416/JCST2019-00055

Keywords: Microwave dielectric properties, LTCC, Li₂O-3ZnO-5TiO₂

Abstract  |  References  |  Full Article