Articles
All articles | Recent articles
Tape Casting of Si3N4 Sheets for Potential Use as Circuit Substrate for Power Devices
J. Zhang, Y. Duan, X. Li, D. Jiang
State Key Laboratory of High Performance Ceramics and Superfine Microstructures, Shanghai Institute of Ceramics, 1295 Dingxi Road, Shanghai 200050, China
received October 31, 2016, received in revised form February 12, 2017, accepted February 15, 2017
Vol. 8, No. 1, Pages 149-154 DOI: 10.4416/JCST2016-00120
Abstract
Si3N4 ceramics exhibit superior mechanical and electrical properties and potentially high thermal conductivity (200 – 320 W/m·K) at room temperature. They are an excellent prospective circuit substrate for power electronic devices. The literature reports that a great deal of work has been conducted on Si3N4, and Si3N4 ceramics with thermal conductivity as high as 177 W/m·K have been realized. One of the main barriers for the application of Si3N4 is the high cost of their fabrication. Tape casting is a flexible technique for the preparation of ceramic sheets with well-controlled composition and dimensions, and presents a prospective route for the development of Si3N4 substrate at reduced cost.
In this study, Si3N4 substrate was prepared by means of tape casting and the sintered reaction-bonded silicon nitride (SRBSN) technique. Initially, silicon green tapes were prepared by means of organic-solvent-based tape casting. The influences of binder content, plasticizer/binder ratio and solid loading on the tape properties were investigated and optimized. Subsequently, the nitration and sintering process was optimized. The microstructure and thermal properties of the Si3N4 ceramics were investigated. Results showed that the preparation of Si3N4 ceramics by means of tape casting and the reaction-bonded silicon nitride (SRBSN) technique is feasible.
Download Full Article (PDF)
Keywords
Silicon nitride, tape casting, thermal conductivity
References
1. Haggerty, J.S., Lightfoot, A.: Chapter 52. Opportunities for enhancing the thermal conductivities of SiC and Si3N4 ceramics through improved processing. In: Proceedings of the 19th Annual Conference on Composites, Advanced Ceramics, Materials, and Structures - A: Ceramic Engineering and Science Proceedings. The American Ceramic Society, Westerville, Ohio, 16, 475 – 487, (1995).
2 Hirosaki, N., Ogata, S., Kocer, C., Kitagawa, H., Nakamura, Y.: Molecular dynamics calculation of the ideal thermal conductivity of single-crystal α- and β-Si3N4, Phys. Rev. B, 65, 134110 – 1-134110 – 11, (2002).
3 Watari, K.: High thermal conductivity non-oxide ceramics, J. Ceram. Soc. Japan., 109, S7 – S16, (2001).
4 Wasanapiarnpong, T., Wada, S., Imai, M., Yano, T.: Effect of post-sintering heat-treatment on thermal and mechanical properties of Si3N4 ceramics sintered with different additives, J. Eur. Ceram. Soc., 26, 3467 – 3475, (2006).
5 Kitayama, M., Hirao, K., Tsuge, A., Toriyama, M., Kanzaki, S.: Oxygen content in β- Si3N4 crystal lattice, J. Am. Ceram. Soc., 82, 3263 – 3265, (1999).
6 Kitayama, M., Hirao, K., Tsuge, A., Watari, K., Toriyama, M., Kanzaki, S.: Thermal conductivity of β-Si3N4: II, effect of lattice oxygen, J. Am. Ceram. Soc., 83, 1985 – 92, (2000).
7 Zhu, X.W., Sakka, Y., Zhou, Y., Hirao, K., Itatani, K.: A strategy for fabricating textured silicon nitride with enhanced thermal conductivity, J. Eur. Ceram. Soc., 34, 2585 – 2589, (2014).
8 Zhou, Y., Hyuga, H., Kusano, D., Yoshizawa, Y., Hirao, K.: A tough silicon nitride ceramic with high thermal conductivity, Adv. Mater., 23, 4563 – 4567, (2011).
9 Adachi, S., Nagaune, F., Gohara, H., Hitachi, T., Morozumi, A., Dietrich, P., Nishiura, A.: High thermal conductivity technology to realize high power density IGBT modules for electric and hybrid vehicles. In: International exhibition and conference for power electronics, intelligent motion, renewable energy and energy management. PCIM Europe Conference Proceedings, Nuremberg, Germany,1378 – 1384, (2012).
10 Mukherjee, A., Maiti, B., Das Sharma, A., Basu, R.N., Maiti, H.S.: Correlation between slurry rheology, green density and sintered density of tape cast yttria stabilised zirconia, Ceram. Int., 27, 731 – 739, (2001).
11 Li, N., Wen, Z.Y., Liu, Y., Xu, X.G., Lin, J., Gu, Z.H.: Preparation of Na-beta-alumina film by tape casting process, J. Eur. Ceram. Soc., 29, 3031 – 3037, (2009).
12 Ziegler, G., Heinrich, J., Wötting, G.: Review relationship between processing, microstructure and properties of dense and reaction-bonded silicon nitride, J. Mater. Sci., 22, 3041 – 3086, (1987).
13 Li, W.B., Lei, B.Q., Lindbäck, T.: A kinetic model for reaction bonding process of silicon powder compact, J. Eur. Ceram. Soc., 17, 1119 – 1131, (1997).
14 Jovanovic, Z.R.: Kinetics of direct nitridation of pelletized silicon grains in a fluidized bed: Experiment, mechanism and modelling, J. Mater. Sci., 33, 2339 – 2355, (1998).
15 Zhou, Y., Hyuga, H., Kusano, D., Yoshizawa, Y.-I., Ohji, T., Hirao, K.: Development of high thermal conductivity silicon nitride ceramics, J. Asia Ceram. Soc., 3, 221 – 229, (2015).
Copyright
Göller Verlag GmbH